Vol 4, No 2 (2019)

The Study of Precast Concrete Connections

Authors:-Ankit Katiyar, ChandreshKumar Jha

Abstract:-Outlines and discusses necessities for connections in formed concrete buildings, and shows examples from completed structures wherever these necessities are met. A time-proven hypothesis explaining shear behavior at concrete to steel and concrete to concrete interfaces is bestowed. Examples illustrate beam to column connections exploitation this hypothesis. Suggestions for additional study are printed.

 

Though the formed concrete structural systems are being wide used worldwide, Earthquakes are natural disasters that have caused loads of infrastructural injury and loss to human lives. within the past earthquakes, the cost effective formed structural systems had not performed well.

 

The failure of the formed structures was attributed to the poor performance of connections. Connections type the weakest link within the formed concrete structure. For the past four decades although loads of analysis has been dispensed on the behavior of formed structures, a whole understanding of the behavior of formed beam-column connections to lateral loading has not been field demand skills and talents so much on the far side the development engineering and should be a balance amid advanced technology and trends, management, practice abalones and economy.

 

The specimens were classified into 3groups with 2 numbers in every cluster. they're sort I connections - Bolt and Rod connections, sort II connections: Cleat Angle and Stiffened Cleat Connections and sort III connections: fastener Connections. the kind I association consisted of 2 connection details (i) formed connection exploitation JBolt (PC-JB) and (ii) formed connection using rod (PC-TR). II association consisted of 3 connection details (i) formed connection exploitation Cleat Angle (PC-CL) (ii) formed connection using cleat angle and single filler (PC-SS) (iii) formed connection using cleat angle and Double filler (PC-DS). the kind III association consisted of 2 connection details (i) formed connection exploitation fastener bar (PC-DW) and (ii) formed connection using fastener bar and Cleat Angle (PC-DWCL). The formed concrete beam and column close to the joint were additionally elaborated with confinement reinforcement. All the sixteen specimens were tested beneath constant axial load on the higher finish of the column and with cyclic load 

 

The main objective of the study was associate analyze the various particularization of joints in an exterior formed concrete beam-column joint subject to reverse cyclic.

Full Issue

View or download the full issue PDF

Table of Contents