Additive Manufacturing of Polymer Components by Fused Deposition Modelling: Influence of Process Parameters on Mechanical Strength and Dimensional Accuracy

Hardik Patel, Nidhi Shah

Abstract


Fused deposition modelling is among the most accessible additivemanufacturing processes and is increasingly used for functional polymercomponents rather than visual prototypes alone. The mechanical anddimensional quality of printed parts, however, depends strongly on the choice of process parameters. This paper investigates the influence of layer thickness, infill density, and print orientation on the tensile strength and dimensional accuracy of components produced from a common thermoplastic. Standard tensile specimens were printed at several parameter settings and tested, and dimensional deviations were measured against the nominal geometry. The results show that tensile strength increases with infill density and is higher for finer layer thickness, while flat-oriented specimens outperform upright ones because inter-layer bonding governs failure. Dimensional accuracy improves with thinner layers but at the cost of longer build times. The findings provide practical parameter guidance for producing functional fused deposition modelling parts and confirm that strength and accuracy can be tuned, within limits, through informed parameter selection. KEYWORDS: Additive Manufacturing, Fused Deposition Modelling, ProcessParameters, Tensile Strength, Dimensional Accuracy, Infill Density, LayerThickness

Full Text:

PDF 9-16

Refbacks

  • There are currently no refbacks.